Guitar to MIDI: single notes, riffs and strumming
Guitar converts well when you play one note at a time: a riff, a solo line, a bass part on the low strings. Strummed chords are a different story, because six strings hit almost at once and keep ringing together. Here is what to expect and how to get a usable MIDI part either way.
What to expect
- Single-note riffs and melodies: usually close, with a few notes to fix.
- Arpeggios (chord notes picked one by one): good, though ringing strings can make notes longer than played.
- Strummed chords: most chord tones show up, but the notes start a few milliseconds apart and some strings go missing or appear twice.
- Bends, slides and wide vibrato: MIDI has fixed pitches, so a bend comes out as two or three separate notes, or one note at the start pitch.
Record a clean signal
- Clean tone is best. Distortion and fuzz add many extra frequencies that look like notes; if you can, record the dry signal (a DI or the clean channel) and add the effect later in your DAW.
- With an acoustic guitar, a phone 30–50 cm from where the neck meets the body works well. Avoid a noisy room.
- Mute the strings you aren’t playing. Open strings ringing in the background turn into extra notes.
- Make sure the guitar is in tune. A slightly flat string can land a semitone off.
Convert and check by ear
Drop the recording into the audio-to-MIDI converter (MP3 or WAV, up to 5 minutes on a computer); it runs in your browser and nothing is uploaded. The built-in “Guitar” example shows a typical result. Play the MIDI together with the original and listen for wrong notes.
Settings that help with guitar
- Keep melody only: for a solo or lead line, this removes stray lower notes from ringing strings. Leave it off for chords.
- Shortest note: raise it if pick noise and fret buzz become tiny notes.
- Note sensitivity: lower it if string noise turns into notes, raise it if quiet notes after a loud one go missing.
Fix what’s left
- Bends: delete the in-between notes and keep the start or target note, then add pitch bend in your DAW if you need it.
- Strums: if you want block chords, quantize so the notes start together. The assistant can do this for the whole part.
- Octave mistakes on low notes: drag the note up or down twelve semitones.
- Very low notes: guitar goes down to E2 (82 Hz), and the lowest notes are where the converter is least sure. Check them by ear.
Export to your DAW
Export the .mid file and import it into your DAW. It plays on whatever instrument you choose, so you can turn a guitar riff into a synth line or double it with bass.